Controller Position - Pride Go-Chair Owner's Manual

V . C O M F O R T A D J U S T M E N T S
Armrest Width Adjustment
You can change each armrest's width independently of
the other.
NOTE: Changing the armrest width may increase the
overall width of your Go-Chair.
To change the armrest width:
1. Locate the two armrest knobs on each side of the
armrest receiver bracket. See figure 18.
2. Loosen the knobs.
3. Remove the detent pins.
4. Slide the armrests in or out to the desired width.
5. Reinstall the pins and tighten the knobs.
Foot Platform Depth Adjustment
To adjust the foot platform depth:
1. Remove the hardware from the foot platform
bracket. See figure 19.
2. Move the foot platform in or out to the desired
depth.
3. Reinstall the hardware into the foot platform
bracket and tighten.

Controller Position

You can position the controller for either left-hand or
right-hand use.
WARNING! Do not place the controller
cable so that it can be pinched in the
seat frame or the power base frame.
To change the controller position:
1. Turn off the power to the controller.
2. Unplug the controller from the power base.
3. Cut all wire ties securing the controller to the armrest.
4. Flip up the armrest and loosen the setscrew. See
figure 20.
5. Slide the controller out of the armrest.
6. Loosen the setscrew in the other armrest.
7. Place the controller in the other armrest.
8. Tighten the setscrew in each armrest.
9. Use a wire tie to secure the controller to the
armrest.
10. Plug the controller into the power base.
Go-Chair
ARMREST KNOB
(LOCATED ON
SEAT FRAME)
Figure 18. Armrest Width Adjustment
Figure 19. Foot Platform Depth
Figure 20. Controller Position
www.pridemobility.com
DETENT PIN
SETSCREW
25