Setting The Remote Control Backlight Mode - Pioneer BDP-88FD Operating Instructions Manual

Setting the remote control
08
backlight mode
• Default setting : 01 (normal mode)
The backlight lighting pattern can be selected from
among four modes, in consideration of convenience and
battery service life.
Caution
• The setting may be restored to the default after the
batteries are replaced. If this happens, reset it.
 Input the 2-digit code you want to set.
Press the number buttons (0 to 9) to input the code while
pressing
LIGHT.
• 01 (normal mode) : The backlight is turned on and off
with the light button. After it lights, it turns off auto-
matically if no operation is performed for 10 seconds.
• 02 (frequent lighting mode) : The backlight turns on
when any button on the remote control is pressed. It
is turned off with the light button. After it lights, it
turns off automatically if no operation is performed
for 20 seconds.
• 03 (eco mode) : The backlight is turned on and off
with the light button. After it lights, it turns off
automatically if no operation is performed for 5
seconds.
• 04 (off mode) : The backlight does not turn on even
when the light button is pressed.
If the backlight LED lights for three seconds and
continues to flash, the setting has been successfully
completed.
If the backlight LED flashes, the setting has failed.
50
En