Husqvarna Soff-Cut 150 Operator's Manual page 19

Soff-Cut 150 D
• Open the engine throttle lever to full open position for
maximum engine speed.
• Line up the rear guide wheel with the pre-existing saw cut.
• Push down on the saw handle and pull the blade release
lever to slowly lower the saw and drop the rear guide
wheel, then the front guide wheel, into the saw cut.
Note: Do not completely lower the saw and the blade into
the concrete until the front and rear guide wheels are
positively aligned in the saw cut.
• Once the guide wheels are in the saw cut, lower the saw
completely to start chasing the joint.
• Chase an existing saw joint for approximately one foot and
verify blade/guide wheel alignment and that the proper
decorative cut is achieved.
• Increase the forward speed of the saw until the blade and
engine are working at maximum efficiency. Do not force
the saw.
• Maintain an even speed; pushing the saw too fast will
cause the blade to ride up out of the saw joint causing
uneven beveling.
• Do not hit the blade block assembly against any object.
Damage may result.
Stopping
• Raise the blade by pushing down on the handle bar with
both hands to the full and locked position.
• Move the engine throttle lever to the full closed position.
• Turn the switch to the 'OFF" ('O" position).
• Close the fuel valve.
• Clean the machine.
OPERATING
– 19
English