Advertisement
3 Function Instruction
This passage mainly describes the main function and general principle of the PTZ camera. Different system
platforms have different operation methods, generally you should refer to the system manufacturer's operation
manual. Please contact dealer to get necessary information, there are some particular requirements and opera-
tions under specific condition.
3.1
Camera ID
There are two 8-bit switches (SW 1 and SW2 ) on the board, SW2 is for setting communication baud
rate and controlling protocol. (For setting, please refer to 10.5 DIP switch setting besides the factory protocol
(FACTORY) , the PTZ is compatible with various popular protocol ls, such as PECLO-D , PECLO-P, ER NITEC, VCL, M
OLYNX, VICON, SANTACHI, PANASONIC, SAMSUNG, DIAMOND, KALATEL, LILIN, PHILIP S, VIDO B02，AD and so on.
Any controlling command must be based on the objective camera address, and the camera only answer to the
controlling command address which coincide with itsel f. There are three kinds of camera addess:
•
Common address: Use camera's switch number to set address 1- 8 bits, the address range is 1-2 54.
•
Debug address: (Only factory protocol an d PELC O can be set) if camera ID is set 0, u ser may select any ad-
dress to control the PTZ.
3.2 Auto-run motion
Focus/speed proportion pan
When manually adjusting, for far focus situation, the PTZ responds at a high-speed so that touching rocker
slightly may make picture move rapidly, thus cause the picture to lose. To base on humanized d esign, the PTZ au
tomatically adjust pan and tilt rotation according to zoom ne ar and f ar, which make it is convenien t to operate
man ually to make tracking for the object. In the m enu, yo u may change system
parameter setting proport ion pan as ON t o run th is function.
Auto flip
If user holds the joystick in the down position, the camera rotates pan 180 degrees, then the camera
rotates tilts up to 180 degrees . In the menu, you may set the system parameter setting AUTO FLIP as ON
to run this function.
Park action
By the menu" park time" and "park action", use r may set auto-call preset or run tour, pattern, and
scan, etc after pointing a few minutes if t he PTZ doesn't run any motions.
Power up action
By the menu" power up action", after the PTZ powers up or restarts, user may set auto- resume
mo vement s before power up and auto- call preset or run tour, pattern, and scan etc .
8
CHANGE THIS TO WHAT THE PRODUCT IS AND COPY INTO THE MASTER PAGE A
Advertisement
