Table of Contents
Advertisement
9. INSTALLATION / WIRE
CONNECTION GUIDE
CONTENTS
1) Before Starting ...................................................................... 18
2) Package Contents ................................................................. 18
3) General Cautions .................................................................. 18
4) Cautions on Installation ......................................................... 18
5) Installing the Source Unit ...................................................... 18
6) Wiring and Connections ........................................................ 20
7) Connecting the accessories .................................................. 20
1) Before Starting
1. This set is exclusively for use with a negative
ground 12 V power supply.
2. Read these instructions carefully.
3. Be sure to disconnect the battery "terminal" before
starting. This is to prevent short circuits during
installation. (Figure 1)
2) Package Contents
Source unit .................................................. 1
Trim ring ...................................................... 1
Power supply cable ..................................... 1
Owner's manual........................................... 1
Warranty card .............................................. 1
Screws M5x6 mm Double Sems ................. 8
3) General Cautions
1. Do not open the case. There are no
user serviceable parts inside. If you
drop anything into the unit during
installation, consult your dealer or an
authorized Clarion service center.
18
CX505
Battery
Figure 1
Remote control unit ..................................... 1
Battery (CR2025)......................................... 1
Screws M5x6mm Flush mount .................... 8
2. Use a soft, dry cloth to clean the case.
Never use a rough cloth, thinner,
benzine, or alcohol etc. For tough dirt,
apply a little cold or warm water to a
soft cloth and wipe off the dirt gently.
4) Cautions on Installation
1. Prepare all articles necessary for in-
stalling the source unit before starting.
2. Install the unit within 30° of the horizon-
tal plane. (Figure 2)
3. If you have to do any work on the car
body, such as drilling holes, consult
your car dealer beforehand.
Max. 30°
Figure 2
5) Installing the Source Unit
1. Before installation, please make sure proper
connections are conducted and the unit
operates normally. Improper connection may
result in damage to the unit.
2. Use only accessories designed and manufac-
tured for this unit as other unauthorized acces-
sories may result in damage to the unit.
3. Before installation, please fasten all power
cables.
4. DO NOT install the unit close to hot areas
to prevent damage to electrical components
such as the laser head.
5. Install the unit horizontally. Installing the unit at
a vertical angle of more than 30 degrees may
result in worse performance.
4. Use the enclosed screws for installation.
Using other screws can cause damage.
(Figure 3)
Chassis
Damage
Max. 6 mm (M5 screw)
Figure 3
6. To prevent electric sparks, connect the posi-
tive pole first and then the negative pole.
Unit Installation
1. When installing the main unit in NISSAN
vehicles, use the parts attached to the unit
(see "
NISSAN"). When installing the main
unit in TOYOTA vehicles, use the parts
attached to the vehicle
(see "
TOYOTA").
2. Wire as shown in "Wire Connection".
3. Reassemble and secure the unit in the
dashboard and set the face panel and center
panel.
Hide quick links:
Advertisement
Table of Contents
