BMW K 1300 S Rider's Manual page 87

Rear brake-pad wear
limit
min 0.04 in (min 1.0 mm)
(Only friction material with-
out carrier plate. Brake disk
must not be visible through
bore hole of inner brake
pad.)
If the brake rotor is visible:
Dropping below the mini-
mum pad thickness leads
to reduced braking performance
and may result in damage to the
brakes.
In order to ensure the operating
reliability of the brake system,
make sure that the brake pads
are not worn beyond their mini-
mum thickness.
Have the brake pads replaced
at an authorized service facil-
ity, preferably an authorized
BMW Motorrad retailer.
Checking front brake fluid
level
A low fluid level in the
brake reservoir can allow air
to penetrate the brake system.
This significantly reduces braking
efficiency.
Check brake fluid level
regularly.
Make sure ground is level and
firm and hold motorcycle verti-
cally.
with center stand Generation
II OA
Make sure ground is level and
firm and place motorcycle on
its center stand.
Move handlebars into straight-
ahead position.
Read off brake fluid level at
brake-fluid reservoir 1.
The brake fluid level in the
brake-fluid reservoir drops
due to brake pad wear.
8
85
z