Charge The Handset Battery Pack; Powering On The Handset - Linksys CIT310 User Manual

Charge the Handset Battery Pack

1. Slide the cover off the battery compartment.
2. Insert the battery pack (included). The plastic end of the wire will fit into the slot at the lower side of the
compartment. It only fits one way, do not force the connection.
3. Slide the cover on until it snaps into place.
4. Place the handset into the plugged-in USB base station. For the initial charge, let the batteries charge for 16
hours before using the handset. This maximizes battery performance and life.
NOTE: The handset may become warm during the initial charge.

Powering On the Handset

When the handset is fully charged, press and hold down the Power/End Call key to power on the handset until
the standby screen fades.
Proceed to the next section, "Install the PC Phone Software."
Chapter 3: Get Connected
Charge the Handset Battery Pack
Dual Mode Cordless Phone for Yahoo! Messenger with Voice
Figure 3-3: Battery pack
Figure 3-4: Handset on the
Battery slot
installed
Charger
16