Installation Of Transmission Cover Oil Seal; Installation Of Transmission Cover; Drive Shaft With Holder Ring; Installation Of Oil Pan Gasket - Saab V4 Service Manual

E
24. Install
a
oow
baiarn::e
shaft seal
the
tn:ms·
mission cover, using tool 786215. See
INSTALLATION OF TRANSMISSION COVER OIL SEAl.
25. Apply a thin coat of sealing compound to the gasket
mounting surfaces on the intermediate plate and
transmission cover. Position the transmission cover
gasket against the intermediate plate. Center the
transmission cover with the special pilot tool 786214
and secure it with the 9 retaining bolts. See fig.
To facilitate installation of the water pump, the lat-
ter should be secured to the transmission cover be-
fore this is installed on the engine.
INSTALLATION OF TRANSMISSION COVER
l. Transmission cover
2. Centering arbor 786214
210-9
26. lubricate the inner diameter of the balance shaft
pulley
seal with
engine oil.
the
with the balance shaft and install the
flat washer and the bolt.
27. in
the
block
with the
NOTE
The stop plate on the shaft must be 5.02
in. (127.5 mm) from the blunt end. See
DRIVE
SHAFT WITH
HOLDER RING
28. Install the oil pump. Tighten the actual pump bolts
first and then the suction line bolt.
29. Insert the rubber seal in the groove in the rear main
bearing cap.
30. Apply a coat of sealing compound to the two corner
joints where the transmission cover, the intermediate
plate and the edges of the oil pan meet. Position
the oil pan gasket on the block, and insert the two
tabs on the cork gasket under the recesses in the
rear bearing cop rubber seal. See fig.
INSTALLATION Of OIL PAN GASKET
April 1975