Fujitsu PrintPartner 12V Product Description page 59

Level 3 escape code
E S C & a # C
E S C & a # G
E S C & a # H
E S C & a # L
E S C & a # M
E S C & a # P
E S C & a # R
E S C & a # V
E S C & d # D
E S C & d # @
E S C & f # S
E S C & f # X
E S C & f # Y
E S C & k # G
E S C & k # H
E S C & k # S
5-14
Move the cursor to the new column. (#: column number; plus
signed=relatively right, minus signed=relatively left, no sign=absolutely
from the left edge)
Feed paper.
Move the cursor to the new horizontal position. (#: l/720" increments; plus
signed=relatively right, minus signed=relatively left, no sign=absolutely
from the left edge)
Set the left margin at column #. (Left edge=column 0)
Set the right margin at column #. (Left edge=column 0)
Rotate the printing direction. (#: 0 to 90 (<90)=0°, 90 to 180 (< 180)=90°,
180 to 270 (<270)= 180°, 270 or larger=270°)
Move the cursor to the new line. (#: row; plus signed=relatively downward,
minus signed=relatively upward, no sign=absolutely from the top margin)
Move the cursor to the new vertical position. (#: l/720" increments; plus
signed=relatively downward, minus signed=relatively upward, no
sign=absolutely from the top margin)
Auto underline on. (#: 0=fixed position, 3=floating position)
Auto underline off. (#: any value)
Store or recall (push or pop) the cursor position (#: 0=store the current
position, l=move to the last stored position)
Select a macro control function. (#: 0=start definition, l=stop definition,
2=execute, 3=call, 4=enable auto overlay, 5=disable auto overlay, 6=delete
all macros, 7=delete all temporary macros, 8=delete last ID macro, 9=make
temporary, 1 0=make permanent)
Specify a macro ID. (#: macro ID; 0 to 32767)
Specify the interpretation of line termination codes, CR, LF, and FF.
Set the horizontal spacing (HMI). (#: l/120" increments; O-32767, 12= 10
cpi) Select a font pitch for the primary and secondary fonts. (#: 0= 10 cpi,
2=16.66 cpi, 4=12 cpi)
Set the pitch for the primary and secondary fonts (#: 0= 10 cpi, 2= 16.66 cpi)