Advertisement
F E AT U R E S - O P E R AT I O N S
SAVE THESE
INSTRUCTIONS
TECHNICAL SPECIFICATIONS
• Amps: 12.5
• Wattage: 1500W (+5% –10%)
• Working voltage: 120V AC/60Hz
HOW CONVECTION HEAT WORKS
As the heater warms the air, hot air rises into the room.
This forces the cooler air down towards the heater, where
it is warmed. This cycle continues until the desired
temperature has been reached. There is no fan so
operation is virtually silent.
Figure 1
OPERATING INSTRUCTIONS
1. Carefully unpack your heater from box, please save
the carton for off-season storage.
2. Place heater on a firm, level surface.
3. Plug heater into a standard outlet.
NOTE: Avoid overloading your circuit by not using
other high wattage appliances in the same outlet. At
1500 watts, this unit draws 12.5 Amps.
Figure 2
Mode Control
Turn the Mode Control to the desired setting:
0 - Off Mode
If you want to shut off the heater at any time during
operation, turn the Mode Control to Off (0) position.
1 - LOW Heat
The heater will run continuously at 750W.
2 - HIGH Heat
The heater will run continuously at 1500W.
NOTE: To start the heater operation, make sure the
Thermostat Control is turned fully clockwise to the highest
position. Power Light will remain lit until the heater is
switched Off at (0) position.
Thermostat Control
1. Before setting the thermostat, allow heater to operate
and warm up the room. Set the thermostat to the
highest setting (9) to start the heater.
2. When the desired temperature comfort level is
reached, lower the thermostat setting until the heater
stops operating. This is done by moving the
Thermostat Control toward lower setting.
3. The thermostat will now automatically maintain the
pre-set temperature level by turning the heater ON
and OFF.
Thermostat
Control
Power Light
Mode Control
Advertisement
