Homelink ® Wireless Control System* - Programming - Volvo S60 Owner's Manual

WARNING
•
®
If you use HomeLink to open a
garage door or gate, be sure no one is
near the gate or door while it is in
motion.
•
When programming a garage door
opener, it is advised to park outside of
the garage.
•
®
Do not use HomeLink with any
garage door opener that lacks safety
stop and reverse features as required
by U.S. federal safety standards (this
includes any garage door opener
model manufactured before April 1,
1982). A garage door that cannot
detect an object - signaling the door to
stop and reverse - does not meet cur-
rent U.S. federal safety standards. For
more information, contact HomeLink
at: www.homelink.com.
®23
The HomeLink Wireless Control System
provides a convenient way to replace up to
three hand-held radio-frequency (RF) trans-
mitters used to activate devices such as gate
operators, garage door openers, entry door
locks, security systems, even home lighting.
Additional information can be found on the
Internet at, www.homelink.com/
www.youtube.com/HomeLinkGentex or by
phoning the hotline at 1–800–355–3515.
HomeLink and the HomeLink house are registered trademarks of Gentex Corporation.
23
Retain the original transmitter of the RF
device you are programming for use in other
vehicles as well as for future HomeLink pro-
gramming. It is also suggested that upon the
sale of the vehicle, the programmed Home-
Link buttons be erased for security purposes.
Refer to "Resetting HomeLink Buttons" in
®
HomeLink Wireless Control System* – pro-
gramming (p. 103).
Using HomeLink
To operate, simply press and hold the pro-
grammed HomeLink button until the trained
device begins to operate (this may take sev-
eral seconds). Activation will now occur for
the trained device (i.e., garage door opener,
gate operator, security system, entry door
lock, home/office lighting, etc.). For conven-
ience, the hand-held transmitter of the device
may also be used at any time. In the event
that there are still programming difficulties or
questions, contact HomeLink at:
www.homelink.com/www.youtube.com/
HomeLinkGentex or by phoning the hotline at
1–800–355–3515.
NOTE
If the ignition is switched off, HomeLink
will function for 30 minutes after the driv-
er's door has been opened.
03 Instruments and controls
®
HomeLink Wireless Control System*
– programming
The HomeLink Wireless Control System pro-
vides a convenient way to replace up to three
hand-held radio-frequency (RF) transmitters
used to activate devices such as gate opera-
tors, garage door openers, entry door locks,
security systems, even home lighting. Addi-
tional information can be found on the Inter-
net atwww.homelink.com/www.youtube.com/
HomeLinkGentex or by phoning the hotline at
1–800–355–3515.
NOTE
Some vehicles may require the ignition to
be switched on or be in the "accessories"
position for programming and/or operation
of HomeLink. It is also recommended that
a new battery be placed in the hand-held
transmitter of the device being pro-
grammed to HomeLink for quicker training
and accurate transmission of the radio-fre-
quency signal. The HomeLink buttons
must be reset first. When this has been
completed, Homelink is in learning mode
so that you can perform programming.
1. Position the end of your hand-held trans-
mitter 1–3 inches (5–14 cm) away from
the HomeLink button you wish to pro-
gram while keeping the indicator light in
view.
*
Option/accessory, for more information, see Introduction.
03
}}
103