Related Manuals for ADEMCO AMC14X
Summary of Contents for ADEMCO AMC14X
- Page 1 14-Inch 14-Inch 14-Inch 14-Inch 14-Inch Color Monitor Color Monitor Color Monitor Color Monitor Color Monitor Installation and Operating Instructions AMC14 AMC14X...
- Page 2 All information was correct at the time of publication. ADECMCO Video reserves the right to make changes and improvements to the product with- out notice.
- Page 3 WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS PRODUCT TO RAIN OR MOISTURE. DO NOT INSERT ANY METALLIC OBJECT THROUGH VENTILATION GRILLS. WARNING RISK OF ELECTRIC SHOCK DO NOT OPEN WARNING: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK).
-
Page 4: Important Safeguards
14-Inch Color Monitor IMPORTANT SAFEGUARDS READ INSTRUCTIONS – Read the safety and operating instructions before operating the monitor. 2. RETAIN INSTRUCTIONS – Retain the safety and operating instructions for future reference. 3. CLEANING – Unplug video monitor from the wall outlet before cleaning. Do not use liquid cleaners or aerosol cleaners. - Page 5 14-Inch Color Monitor 11. POWER CORDS – Do not allow anything to rest on the power cord. Do not locate video monitor or equipment where the cord can be damaged by persons walking on it. 12. HEED WARNINGS – Follow all instructions marked on the video monitor. 13.
-
Page 6: Fcc Compliance Statement
14-Inch Color Monitor FCC COMPLIANCE STATEMENT INFORMATION TO THE USER: THIS EQUIPMENT HAS BEEN TESTED AND FOUND TO COMPLY WITH THE LIMITS FOR A CLASS B DIGITAL DEVICE, PURSUANT TO PART 15 OF THE FCC RULES. THESE LIMITS ARE DESIGNED TO PROVIDE REASONABLE PROTECTION AGAINST HARMFUL INTERFERENCE IN A RESIDENTIAL INSTALLATION. -
Page 7: Table Of Contents
14-Inch Color Monitor Table of Contents Chapter 1 – Introduction..........1 Features ................. 1 Technical Overview ..............1 Chapter 2 – Installation ..........Required Installation Tools ............. 4 Installation Instructions ............4 Chapter 3 – Operation..........Appendix A – Troubleshooting ........9 Appendix B –... - Page 8 14-Inch Color Monitor AMC14...
-
Page 9: Chapter 1 - Introduction
• Switchable Y/C 75 Ohm termination Technical Overview The ADEMCO AMC14 is a 14-inch color monitor that can be switched between two video sources. The picture quality control knobs easily accessible on the front panel. LEDs beside the selector buttons indicate which video source is being displayed. - Page 10 14-Inch Color Monitor The monitor has both composite BNC connectors and Y/C mini DIN connectors. The BNC connectors are auto terminating. The user can use the output connector for loop-through video without setting a termination switch. The Y/C connectors can be switched between high impedance and 75 Ohm termination.
-
Page 11: Chapter 2 - Installation
14-Inch Color Monitor Chapter 2 – Installation Figure 2 – Front panel controls Figure 3 – Rear panel connectors AMC14... -
Page 12: Required Installation Tools
14-Inch Color Monitor Required Installation Tools Installing the AMC14 monitor does not require any special tools. Installation Instructions WARNING: The monitor should be installed in an area that is clean, dry and well ventilated. Do NOT install the monitor where it can get wet;... -
Page 13: Figure 4 - Single Monitor Connection
14-Inch Color Monitor Figure 4 – Single monitor connection The S-VHS connectors can be used with VCRs that have S-VHS input and output connctors. When using the Y/C connectors, make certain the Impedance switch is set correctly. Set it to the HIGH position when looping video through. -
Page 14: Figure 7 - Multiple Monitor Connection
14-Inch Color Monitor If you plan to loop the video out to another monitor, connect a cable to the Video Out BNC and route it to the Video In of the second monitor. Up to three monitors can be connected using the loop-through feature. Figure 7 –... -
Page 15: Chapter 3 - Operation
14-Inch Color Monitor Chapter 3 – Operation Figure 8 – Front panel controls To turn on the monitor, press the power button on the front panel. After a few seconds, video should appear on the monitor. If video does not appear, refer to the Troubleshooting section of this manual. - Page 16 14-Inch Color Monitor The COLOR knob controls the color saturation of the picture on the monitor. Turning the knob counterclockwise will produce a low saturation (pale) picture. Turning the knob clockwise will increase the color saturation (intensity). The TINT knob adjusts the color phase between red and green. Adjust the knob until skin tones appear natural (NTSC only).
-
Page 17: Appendix A - Troubleshooting
14-Inch Color Monitor Appendix A – Troubleshooting Problem Possible Solution No Video Check that all components in the system (monitor, cameras, VCRs, multiplexers, etc.) have power and are turned on. Check that the camera lens cap is removed and the lens is set to proper aperture. -
Page 18: Problem Possible Solution
14-Inch Color Monitor Problem Possible Solution Fuzzy Video If the camera has a manual focus lens, check that it is properly focused. If the camera has an autofocus lens, ensure that it is working properly. Check that the back focus ring on the camera has been adjusted correctly. -
Page 19: Appendix B - Specifications
14-Inch Color Monitor Appendix B – Specifications PICTURE TUBE ..............14" (13.3" useable) Deflection ..................90° angle POWER SOURCE ....90 to 132 VAC and198 to 264VAC, 50Hz or 60Hz POWER CONSUMPTION ..............70 Watts VIDEO STANDARD ................. NTSC/PAL RESOLUTION ............. 400 TV lines (at center) SCANNING FREQUENCY Horizontal .......... - Page 20 Netherlands Tsuen Wan, N.T 31-299-419-000 Hong Kong 852-2405-2323 Video Controls Ltd. Aston Fields Rd. LATIN AMERICA Whitehouse Ind. Est ADEMCO International (Latin America) Runcorn UK WA7 3DL 1769 NW 79 Ave. Miami, FL 33126 44-1928-754000 1-305-477-5204 AMC14 & AMC14X AMC14Q0401...