5) Select menu "Auto", then select items "All chip", "program" and other switches as Fig. 5
6) Press key "Run" as Fig. 4 to begin burning software, there are two steps for the process: Erase
and Program
normal burning processes are as follows:
the first course "Erasing..., Flash Status: 03" will be lasting for a moment, otherwise skipping
over means unsuccessful erasing; please confirm process (2) and then burn software again;
the following course "Programming...,Flash Status:00" will be done until a prompt "Pass" is
displayed.
7) A prompt "Pass" will be displayed beside the key "Run" for successful burning as Fig. 6
Fig. 6 A prompt "Pass" beside the key "Run" for successful burning
8) Need not exit from ISP burning interface and only repeat the process 3)and 5)to go on burning
software for other sets.
Note 3: On-line burning and upgrading method from USB port
1) Be sure to format a U disk as FAT32;
2) Copy program file to the U disk with the name "Merge.bin";
Fig. 5 Burning Config