Advertisement
L.?! Gas
Conversion
Natural
A.
Pressure Regulator:
Use a wrench to
unscrew the cap from
the top by turning counte
clockwise
Turn the cap over so the hole
end is up. Replace the cap and gasket
on the regulator. DO NOT REMOVE THE
PRESSURE REGULATOR. ,,
1
Flame Broiler
b
Burner: Remove
1 the oven burner
-by
pressing in on front of burner
until retainer clips loosen. Gently pull
burner out and down until orifice spud
can be reached.
Care must be taken
not to break the ignitor coil. Carefully
put
the burner aside so screen side is up,
Remove the burner orifice spud, using a
5/i/' wrench. Take the LF! orifice spud out
of the compartment
on the left oven wall
and place the Natural gas orifice spud
in the compartment.
Put the L.P orifice
spud in place.
Replace the burner so the screen louvers
face the rear of oven. No gas input or air
shutter adjustment
is necessan/.
C
After the burner has been
W converted
to L.P aas usaae
and gas line is connectedycheckyor
leaks. Use a brush and liquid detergenl
to test all gas connections
for leaks.
Bubbles around connections
will
indicate
a leak. If a leak appears,
shut
off gas valve controls and adjust
connections.
Then check connections
again. NEVER TEST FOR GAS LEAKS
WITH A MATCH OR OTHER FLAME.
Venting Installation
This oven is equipped
with either inside
or optional
outside venting. Follow
instructions for your application.
Inside Venting-no
adjustments are
necessary, oven will vent into the
kitchen through the vent in the control
panel housing.
Outside Venting-To
use outside
venting, the flue collar cap and cover
(located
under the top heat shield]
must be removed.
When outside stack venting (Method
#t. see illustration] is required, use only
Class "A" or "B" approved
materials
Venting must conform to local
ordinances.
Cablnel
back
must be
mrtombte
horn hunt.
F oven
unii
(not to floor)
1
For rear wall connection
[Method
#2,
see illustration) provide a Class "B:'4"
I.D. opening at the center line of the
cabinet
cut out. The height of the
opening
is determined
by the height
of the unit from the floor and the face
to center dimensions of the stack
connections.
The wall oven vent may not be
connected
into a ventilation
system
which already
provides discharge
from another household
appliance.
Note: The centerline
of the flue pipe
and the cabinet
must be aligned.
OUTLET MUST BE TERMINATED ABOVE
ROOFLINE.
Part No 36.C!61039-02-O/78680
Rev A
Prepared
by WhQxxl
Corporation.
Benton
Harbor,
Michlgon
49022
Printed
I" US A
Advertisement
