Door Disassembly; Turntable Motor; Steam Sensor Nn-T589Wb - Panasonic NN-T559WB Service Manual

6.6 Door disassembly

1. Remove door C from door E by carefully pulling outward
starting from upper right hand corner using a flat blade
screwdriver.
2. Remove 4 screws holding door E to door A assembly to
separate door E from door A.
3. Remove door key and door key spring.
After replacement of the defective component parts of the
door, reassemble it and follow the instructions below for
proper installation and adjustment so as to prevent an
excessive microwave leakage.
1. When mounting the door to the oven, be sure to adjust the
door parallel to the bottom line of the oven face plate by
moving the upper hinge and lower hinge in the direction
necessary for proper alignment.
2. Adjust so that the door has no play between the inner door
surface and oven front surface. If the door assembly is not
mounted properly, microwave power may leak from the
clearance between the door and oven.
3. Perform the microwave leakage test.
DOOR A
ASSY
DOOR HOOK
SPRING

6.7 Turntable motor

1. Remove the motor cover by breaking off at the 8 spots
indicated by arrows. (See Figure)
NOTE: After breaking off the motor cover, make sure that
cut-off portions are properly trimmed off or bend to
inside so that no sharp edge will expose to outside.
2. Disconnect 2 lead wires connected to the turntable motor.
3. Remove the turntable motor by removing 2 screws.
NOTE: To reinstall the motor cover, use 4x6 screw.
DOOR E

6.8 Steam Sensor NN-T589WB

SCREWS
1. Remove 1 screw holding steam sensor unit.
2. Disconnect CN2 connector from digital programmer circuit
3. Remove exhaust guide from steam sensor unit.
4. Remove catch hooks on sensor mounting plate and air
DOOR C
5. Remove steam sensor from sensor mounting plate.
NOTE: When installing the steam sensor, make sure that the
01-027
SENSOR MOUNTING PLATE
METAL
SURFACE
14
BASE
MOTOR
COVER
board.
guide.
direction of the steam sensor is as shown in figure.
SENSOR MOUNTING PLATE
EXHAUST GUIDE
HOOK
TURNTABLE MOTOR
SCREW
HOOK
AIR GUIDE
SURFACE OF LEAD WIRE
(WHITE SURFACE)