Troubleshooting Guide; Specifications - Panasonic SH-FX71 Operating Instructions Manual

SH-FX71_RQTX1132-G_En.book Page 11 Friday, December 4, 2009 12:05 PM

Troubleshooting guide

Before requesting service, make the following checks. If you are in doubt
about some of the check points, or if the solutions indicated in the table do
not solve the problem, consult your dealer for instructions.
Main unit
No power.
Ensure the AC mains lead is connected properly.
The indicator does not turn green even though [I/D SET] is pressed
and completed the pairing.
Turn the wireless system off and then back on.
Power of this unit is turned off when the input for the TV is changed.
≥ Refer to page 8 for the surround selector setting details and ensure that
the selector is set at the correct position. Then, turn the wireless system
off and then back on.
≥ Verify the surround sound setting on the home theater unit.
The wireless link indicator keeps flashing between red and green.
There is a power supply problem. Consult the dealer.
On your home theater unit
The wireless link indicator
(e.g. " [W] " or an indicator) is flashing.
There is no link between the home theater unit and the wireless system.
Turn the wireless system off and then back on. Alternatively, turn the
wireless system off, disconnect the AC mains lead, and then reconnect it.
The wireless link indicator
(e.g. " [W] " or an indicator) does not light.
≥ Check that the home theater unit is turned on, and the wireless system
is turned on.
≥ Ensure that the digital transmitter is fully inserted into the slot of the
home theater unit.

Specifications

AMPLIFIER SECTION
RMS output power
Surround Ch 125 W per channel (3 ≠), 1 kHz, 10 % THD
Total RMS power
DIN output power
Surround Ch 70 W per channel (3 ≠), 1 kHz, 1 % THD
Total DIN power
GENERAL
Power supply [Australia[and[N.Z.[
[Others[
Power consumption
Digital transmitter
Wireless system
Dimensions (WtHtD)
Digital transmitter
Wireless system
Mass
Digital transmitter
Wireless system
Wireless module
Frequency range
Number of channels
Operating temperature range
Operating humidity range 20 % to 80 % RH (no condensation)
Power consumption in off mode
[Note]
1 Specifications are subject to change without notice.
Mass and dimensions are approximate.
2 Total harmonic distortion is measured by a digital spectrum analyzer.
250 W
140 W
AC 220 V to 240 V, 50 Hz
AC 110 V to 127 V/
220 V to 240 V, 50/60 Hz
1.2 W
43 W
43.3 mmk37.3 mmk8.2 mm
165 mmk91.5 mmk164 mm
0.0095 kg
0.695 kg
2.4 GHz to 2.4835 GHz
3
0 oC to r40 oC
approx. 0.3 W
11