Electrical Specifications - Sharp 28JW-74H Service Manual

Pal i system colour television

Hide thumbs

Table of Contents

•Power Input .................... 220V-240 Volts AC 50Hz

•Power Consumption

Normal Operation (Method IEC60107) ............ 80W

Stand-by Operation ............................................ 3W

•Audio Power Output Rating (MPO) / Impedance

Internal Left Speaker ................................. 10W, 7

Internal Right Speaker .............................. 10W, 7

•Speakers

Left / Right ................................................. 12 x 6cm

•Convergence (Maximum Misconvergence)

Static (Centre) between any two colours ... 0.08 cm

Dynamic after static equals zero

Within 10cm (4") circle ....................... 0.12cm

10-25cm (4-10" ) circle ...................... 0.20 cm

Everywhere else ................................ 0.28 cm

•White Level

Set brightness control to get total picture tube cathode current of 600 µA under no signal condition.

Maximum necessary correction of each picture tube cathode current to get 8900 degrees K-20 MPCD

screen temperature should not exceed 15% of its original value.

The chassis in this receiver is partially hot. Use an isolation transformer between the line cord plug

and power receptacle, when servicing this chassis.

To prevent electric shock, do not remove cover. No user-serviceable parts inside. Refer servicing to

qualified service personnel.