Table of Contents
Advertisement
Quick Links
Download this manual
See also:
Instruction Manual
Advertisement
Table of Contents
Related Manuals for SSP MGA701
Summary of Contents for SSP MGA701
- Page 1 INSTRUCTION MANUAL Angle Grinder MGA701 MGA901 011097 DOUBLE INSULATION IMPORTANT: Read Before Using.
-
Page 2: Specifications
EN60745: national law, electric equipment that have reached the end of their life must Model MGA701 be collected separately and returned to Work mode : surface grinding an environmentally compatible recycling Vibration emission (a ) : 5 m/s facility. - Page 3 Power tool plugs must match the outlet. Never Angle Grinder modify the plug in any way. Do not use any Model No./ Type: MGA701,MGA901 adapter plugs with earthed (grounded) power are of series production and tools. Unmodified plugs and matching outlets will Conforms to the following European Directives: reduce risk of electric shock.
-
Page 4: Grinder Safety Warnings
a cord suitable for outdoor use reduces the risk of 20. Disconnect the plug from the power source electric shock. and/or the battery pack from the power tool If operating a power tool in a damp location is before making any adjustments, changing unavoidable, use a residual current device accessories, or storing power tools. - Page 5 accessory can be attached to your power tool, it Position the cord clear of the spinning does not assure safe operation. accessory. If you lose control, the cord may be cut The rated speed of the accessory must be at or snagged and your hand or arm may be pulled least equal to the maximum speed marked on into the spinning accessory.
- Page 6 d) Use special care when working corners, occur. Investigate and take corrective action to sharp edges etc. Avoid bouncing and snagging eliminate the cause of wheel binding the accessory. Corners, sharp edges or bouncing d) Do not restart the cutting operation in the have a tendency to snag the rotating accessory and workpiece.
-
Page 7: Functional Description
22. Use the specified surface of the wheel to FUNCTIONAL DESCRIPTION perform the grinding. 23. Watch out for flying sparks. Hold the tool so that sparks fly away from you and other CAUTION: persons or flammable materials. Always be sure that the tool is switched off and •... - Page 8 For tool with the lock on and lock-off switch 1. Wheel guard To prevent the switch trigger from accidentally pulled, a 2. Screw lock lever is provided. 3. Bearing box To start the tool, push in the lock lever (in the A direction) and then pull the switch trigger (in the B direction).
-
Page 9: Operation
ALWAYS hold the tool firmly with one hand on rear 1. Lock nut wrench handle and the other on the side handle. Turn the tool on 2. Shaft lock and then apply the wheel or disc to the workpiece. In general, keep the edge of the wheel or disc at an angle of about 15 degrees to the workpiece surface. -
Page 10: Maintenance
1. Wire wheel 1. Lock nut brush 2. Abrasive cut-off wheel/diamond wheel 3. Inner flange 4. Wheel guard for abrasive cut-off wheel/diamond wheel 011108 010828 Unplug tool and place it upside down allowing easy When installing a diamond wheel with its 7 mm or thicker access to spindle. - Page 11 become obstructed. Replacing carbon brushes 1. Commutator 2. Insulating tip 3. Carbon brush 001146 When the resin insulating tip inside the carbon brush is exposed to contact the commutator, it will automatically shut off the motor. When this occurs, both carbon brushes should be replaced.
- Page 12 Makita Corporation Anjo, Aichi, Japan www.makita.com 884970-895...