Description - Hilti TE 50 Operating Instructions Manual

Obligation signs
en Wear eye Wear a hard
protection
Wear
breathing
protection
Symbols
Read the Return waste
operating material for
instructions recycling.
before use
Chiseling Chisel
position
adjustment

2 Description

2.1 Use of the product as directed
The power tool is an electrically-powered combihammer with pneumatic hammering mechanism.
The power tool is intended for drilling in concrete, masonry, metal and wood.
The power tool can also be used for light to medium-duty chiseling work on masonry and for surface finishing on
concrete.
Working on materials hazardous to the health (e.g. asbestos) is not permissible.
Nationally applicable industrial safety regulations must be observed.
The power tool is designed for professional use and may be operated, serviced and maintained only by trained,
authorized personnel. This personnel must be informed of any special hazards that may be encountered. The power
tool and its ancillary equipment may present hazards when used incorrectly by untrained personnel or when used not
as directed.
The working environment may be as follows: construction site, workshop, renovation, conversion or new construction.
The power tool may be used only in a dry environment.
Do not use the power tool where there is a risk of fire or explosion.
The power tool may be operated only when connected to a power supply providing a voltage and frequency in
compliance with the information given on its type identification plate.
Modification of the power tool or tampering with its parts is not permissible.
To avoid the risk of injury, use only genuine Hilti accessories and insert tools.
Observe the information printed in the operating instructions concerning operation, care and maintenance.
2
Wear ear
hat protection
Drilling
without
hammering
Volts
Alternating
current
Wear
protective
gloves
Revolutions
per minute
Lock symbol
Location of identification data on the power tool
Hammer
drilling
The type designation and serial number can be found
on the type identification plate on the machine or tool.
Make a note of this data in your operating instructions
and always refer to it when making an enquiry to your
Hilti representative or service department.
Type:
Amps
Serial no.:
Hertz Rated speed
under no
load
Diameter Double
insulated
Revolutions
per minute
Equipped
with theft
protection
system