Appliance Break-In; Heat Management - Heatilator ECLIPSE-32 Owner's Manual

G. Appliance Break-In
Initial Break-in Procedure
• The fireplace should be run three to four hours
continuously on high.
• Turn the fi replace off and allow it to completely cool.
• Remove fi xed glass assembly. See Section 4.
• Clean fi xed glass assembly. See Section 4.
• Replace the fi xed glass assembly and run continuously
on high an additional 12 hours.
This cures the materials used to manufacture the fi re-
place.
NOTICE! Open windows for air circulation during fi re-
place break-in.
• Some people may be sensitive to smoke and odors.
• Smoke detectors may activate.
H. Heat Management
Heat Output
The ECLIPSE-32 and ECLIPSE-36 models have a
variable burn rate which is controlled by the HI/LO knob
on the gas valve. Therefore the fl ame height is adjustable.
The HI/LO knob is shown in Figure 3.4. It is located in the
control cavity of the appliance. The HI/LO knob may be
adjusted as desired by turning counterclockwise to the
HIGH position and by turning clockwise to the LO position.
If an optional fan is installed, the fan speed is controlled
by adjusting the speed control knob.
clockwise to increase the fan speed and counterclockwise
to decrease the fan speed.
Figure 3.4 Control Cavity/Valve Location
12
Turn the knob
VALVE CONTROL
CAVITY
LOCATION
Heatilator • ECLIPSE-32, ECLIPSE-36 Owner's Manual • 2297-985 Rev. C • 4/15