Section 2: Set-Up Adjustments; Beam Landing - Sony KV-27FS320 Service Manual

The following adjustments should be made when a complete
realignment is required or a new picture tube is installed.
These adjustments should be performed with rated power supply
voltage unless otherwise noted.
Set the controls as follows unless otherwise noted:
VIDEO MODE: Pro
PICTURE CONTROL: Normal
BRIGHTNESS CONTROL: Normal

2-1. BEAM LANDING

Before beginning adjustment procedure:
1. Feed in the white pattern signal.
ADJUSTMENT PROCEDURE
1. Input a raster signal with the pattern generator.
2. Loosen the defl ection yoke mounting screw, and set the purity
control to the center as shown below:
Purity Control
3. Turn the raster signal of the pattern generator to green.
4. Move the defl ection yoke backward, and adjust with the purity control
so that green is in the center and red and blue are even on both
sides.
5. Move the defl ection yoke forward, and adjust so that the entire
screen becomes green.
KV-27FS320/32FS120/32FS320/34FS120/36FS120/36FS320/38FS120

SECTION 2: SET-UP ADJUSTMENTS

Blue Red
Green
KV-27FS320/32FS120/32FS320/34FS120/36FS120/36FS320/38FS120
Perform the adjustments in order as follows:
1. Beam Landing
2. Convergence
3. Focus
4. Screen (G2)
5. White Balance
Note Test Equipment Required:
1. Color Bar Pattern Generator
2. Degausser
3. DC Power Supply
4. Digital Multimeter
6. Switch over the raster signal to red and blue and confi rm the
condition.
7. When the position of the defl ection yoke is determined, tighten it with
the defl ection yoke mounting screw.
8. If landing at the corner is not right, adjust by using the disk magnets.
corrects this area.
Disk magnets
or rotatable disk
magnets correct
these areas (a-d).
Deflection yoke positioning
b
d
Purity control
a b
c d
corrects these areas.
a
c
31