Table of Contents
Advertisement
DIVAR IP 7000 1U
Rear view:
2.3.1
Control panel buttons
There are two push-buttons located on the front of the chassis. These are (in order from left
to right) a reset button and a power on/off button.
–
–
2.3.2
Control panel LEDs
The control panel located on the front of the chassis has LEDs to provide you with critical
information related to different parts of the system. This section explains what each LED
indicates.
–
–
–
Bosch Sicherheitssysteme GmbH
1
2x mains connection 100 – 240 VAC,
50 - 60 Hz
Note: Connect both power cables.
2
2x PS/2 (mouse and keyboard)
3
2x USB 2.0
4
Serial interface COM
Reset: The reset button is used to reboot the system.
Power: The main power switch is used to apply or remove power from the power
supply to the server system. Turning off system power with this button removes the main
power but keeps standby power supplied to the system. Therefore, you must unplug
system before servicing.
Information LED: not used
NiC2: A flashing LED indicates network activity on GLAN2.
NIC1: A flashing LED indicates network activity on GLAN1.
5
6
7
Installation Manual
System overview | en
Monitor (VGA)
Note: Do not use!
2x NIC
Note: Connect both NIC ports to the
appropriate network switch.
1x graphic card (1x Display Port,
1x DVI)
Note: DVI port must be used for
configuration.
11
2014.12 | V3 | DOC
Advertisement
Table of Contents
