Table of Contents
Advertisement
Installation Requirements
Before beginning the installation, review the criteria below to make sure that the requirements have been or will be met when the
installation is complete. Also,confirm that the feed water falls within the limits shown below. If you're not sure if this has been done,
check with your SteamerGard distributor or the factory before installing the system. This is important because failures caused by
water related problems are not covered under the system warranty.
Operating parameters:
Model
Operating pressure
Typical TDS rejection
Feed Temperature
Feed pressure
Production*
*Model number equals nominal production in gallons per day @ 77°F (25°C) @ 500 ppm based on 24 hr day. Actual output may vary
according to local water conditions and membrane variations.
175 psi
>96%
40- 100° F (4-38° C)
25 - 85 psi (1.4 - 5.9 bar) at 3 gpm
WT-300, WT-600, WT-900
1
Advertisement
Table of Contents
