Circuit Breakers - Lincoln Electric BULLDOG IM10074 Operator's Manual

Engine driven welder
Table of Contents

Advertisement

A-6
A-6
INSTALLATION
PREMISES WIRING
The BULLDOG™ 5500 is not recommended for
premises wiring.
The BULLDOG™ 5500 does not have a combined
120/240 volt receptacle and cannot be connected to a
premises as described in other Lincoln literature.
Remember that the BULLDOG™ 5500 is intended
only for backup, intermittent use power.
Certain electrical devices cannot be powered by the
BULLDOG™ 5500. Refer to Table A.2 for these
devices.

CIRCUIT bREAKERS

Auxiliary power is protected by circuit breakers. When
the machine is operated in high temperature environ-
ments, the breakers may tend to trip at lower loads
than normally.
CAUTION
Never bypass the circuit breakers. Without over-
load protection, the BULLDOG™ 5500 could over-
heat and/or cause damage to the equipment being
used.
------------------------------------------------------------------------
bULLDOG™ 5500

Advertisement

Table of Contents
loading

This manual is also suitable for:

Bulldog 5500K2708-2

Table of Contents