MZ-R910
3-12. "MOTOR, DC (SPINDLE) (M601)", "MOTOR, DC (OVER WRITE HEAD UP/DOWN) (M603)"
1 Remove six solders of
motor flexible board.
4 Three screws
(M1.4)
5 Motor, DC
(spindle) (M601)
12
qa Motor, DC (over write head up/down)
(M603)
6 Two screws (M1.4)
qs Chassis assy, gear
9 Screw (M1.2)
Note: Press-fit the gear (HA) up to the
position of the "motor, DC (over
write head up/down) (M603) as shown
below.
Gear (HA)
2.65 mm
Chassis assy, gear
Motor, DC (over write head
up/down) (M603)
0 Gear (HA)
8 Gear (HB)
7 Washer (0.8-2.5)
2 Washer (0.8-2.5)
3 Gear (HC)