Lincoln 2011 MKS Owner's Manual page 61

Lights
Note: The programming sequence will end if either of the following
occur:
• The vehicle speed is not zero.
• The battery voltage is out of normal range.
Troubleshooting
If the automatic high beam camera becomes blocked, the high beams
may not come on automatically. They will only activate when they are
manually turned on with the multi-function lever.
Typical road dust, dirt and water spots will not affect the automatic high
beam system's performance. However, in cold or inclement weather
conditions, the automatic high beam system's availability may be
decreased. In such conditions, the manual override may be used to turn
the high beams on or off.
For significant blockages (e.g. bird dropping, bug splatter, snow, or ice),
the automatic high beam system uses a blocked sensor computer
program. If a blockage is detected and no changes are observed, the
system will go into low beam mode until the blockage is cleared. If
blockages are repeatedly detected, the system will stay in low beam
mode for the remainder of the ignition cycle unless the system is able to
begin detecting other vehicles again.
If it appears that automatic control of the high beams is not functioning
properly, check the windshield in front of the camera for blockage.
Flash-to-pass
Pull and release to activate.
Daytime running lamps (DRL) (if equipped)
To activate:
• the ignition must be in the on position,
• the headlamp control must be in the off, autolamps or parking lamp
position and
61
2011 MKS (mks)
Owners Guide, 1st Printing
USA (fus)