Pioneer AVIC-Z110BT Service Manual page 146

1
-
Removing the Case Unit (Fig.4)
A
Remove the six screws.
1
Remove the four hooks
2
and then remove the Case Unit.
B
Note)
When the Case Unit is not removed easily,
Remove by pushing the hook of the Grille Unit from the hole of the Case Unit.
Do not damage the Grille Unit.
When unplugging the Coaxial Jumper, make sure to use jig GGF1539.
If the antenna cable is directly unplugged without using jig GGF1539, you might damage your fingertip or fingernail.
C - How to Remove the Coaxial Jumper
When unplugging Coaxial Jumper, hook the point of jig GGF1539 on the lid of Coaxial Jumper
and vertically draw out along with the engagement axis of connector.
D
- How to Attach the Coaxial Jumper
For inserting Coaxial Jumper, adjust cord assy with the engagement axis of connector and insert it as vertically
as possible.
Do not insert the Coaxial Jumper in extreme slant, as the connector might suffer damage.
E
F
146
1
2
1
2
2
GGF1539
Coaxial Jumper
AVIC-Z110BT/XN/UC
2
3
1
1
2
2
Grille Unit
Connector
3
4
1
1
Case Unit
Fig.4
4