Table of Contents
Advertisement
Manual image setup
Downloaded from ManualMonitor.com Manuals
Table 3-2. Troubleshooting (continued)
Problem
Possible cause
Screen is blank
The monitor is in
and power
Standby/Suspend
indicator is
mode
steady amber or
flashing green
The power
The video signal
indicator is
cable is loose or
green, but there
disconnected
is no image.
from the system
or monitor.
The monitor
brightness and
contrast are at
the lowest
setting.
One or more of
This is a
the pixels appear
characteristic of
discolored
the LCD
technology and
is not an LCD
defect.
v Fuzzy lines in
v Image setup
text or a
has not been
blurry image.
optimized
v Horizontal or
v Your system
vertical lines
Display
through the
Properties
image.
setting have
not been
optimized.
If automatic image setup does not establish the image that you prefer, perform
manual image setup.
Note: Have your monitor powered on for about 15 minutes, until the monitor
warms up.
1. Press
at the bottom of the monitor to open the OSD menu.
2. Use
or
to select
3. Use
or
to select Clock and Phase adjustment.
Suggested action
v Press any key on the
keyboard or move the
mouse to restore
operation.
v Check the Power
Options settings on
your computer.
Be sure the video cable is
connected with the
system properly.
Adjust the brightness and
contrast setting on the
OSD menu.
If there are more than
five pixels missing,
contact the Customer
Support Center.
Adjust the resolution
settings on your system
to match the native
resolution for this
1440 x 900
monitor:
at 60
Hz.
Perform automatic image
setup. If automatic image
setup does not help,
perform manual image
setup.
When working in the
native resolution, you
may find additional
improvements by
adjusting the Dots Per
Inch (DPI) setting on
your system.
and press
to access.
Chapter 3. Reference information
Reference
"Understanding power
management" on page
2-6
"Connecting and turning
on your monitor" on
page 1-3
"Adjusting your monitor
image" on page 2-3
Appendix A, "Service and
Support," on page A-1
"Adjusting your monitor
image" on page 2-3
"Manual image setup"
"Selecting a supported
display mode" on page
2-5
See the Advanced section
of your system's display
properties.
3-3
Advertisement
Table of Contents
