Lightolier PTS7-4 Specifications

Complete ordering instructions on back.
Sample Run, End Plate and Corner Block Accessories
End Cap Set
PTS7EP Standard
PTS7EPA Air
14" (35.56cm)
90° Inside 90° Outside
PTS7C901 Standard PTS7C900 Standard
PTS7C901A Air PTS7C900A Air
Features
1. Housing: Die-formed steel, slotted for air return. Integral flanges at each end
strengthen the housing and permit housings to be bolted together in continuous
runs and facilitate suspension of fixture. Concealed openings for heat extraction
and air return.
2. Lamping: Two T8 or T12 fluorescent lamps, as specified. Provided by others.
3. Reflector: Die-formed semi-specular aluminum.
4. Louver: Semi-specular anodized aluminum, 40° lengthwise by 30° minimum
crosswise shielding. Supported along both edges by concealed frame of
extruded aluminum. Bold baffle, prismatic lens, gold anodized louver, open or
egg crate louver available, consult factory.
5. Socket Channels: Die-formed, pre-painted steel held by support brackets and
allows for up to 6" (15.24cm) lamp overlap.
6. Ceiling Trim: Extruded aluminum with integral aligner splines.
7. Air Supply Channel: For air supply or ducted air return. Ducted air return
requires Anemostat #PRTS or equivelant (by others).
Electrical
Specify 120 volt or 277 volt. 3 conductor, 18 gauge wire. Color-coded quick
connectors allow ease of connection for joiner modules. For special circuiting,
consult factory. Factory installed ballast disconnect allows the ballast to be
disconnected from and reconnected to incoming power under load without turning
the entire circuit off.
Dimming: Advance Mark X, use Advance compatible two-wire control (no extra
control lead required).
7 -1/16"
(19.94cm)
1
7
1-5/16" (3.33cm)
8 -1/2" (245.11cm)
1-1/2"
(3.81cm)
135° Inside
PTS7C1351 Standard
PTS7C1351A Air
Lighting Systems
11-1/4" (28.58cm)
5
2 3
6
8-1/4" (20.96cm)
4-3/4" (12.07cm)
135° Outside
PTS7C1350 Standard
PTS7C1350A Air
Mountings
Wall Adjustment Bracket - Allows for inconsistencies in wall straightness.
Die-formed steel used to mount system to the wall.
Finish
Ceiling trim painted baked enamel semi-gloss white.
Options and Accessories
90° inside, 90° outside, 135° inside, and 135° outside corerns available.
Labels
UL, cUL and I.B.E.W.
Job Information
Job Name:
Cat. No.:
Lamp(s):
Notes:
We reserve the right to change details of design, materials and finish.
PTS7-4
4
Quarter Scale
Type: