Led Error Messages; Mage Roblems - Vivitek D950HD User Manual

D L P P r o j e c t o r — U s e
D L P P r o j e c t o r — U s e
D L P P r o j e c t o r — U s e

LED Error Messages

E C
RROR
Lamp Ready
Start
Cooling
Over temperature
Thermal Break Sensor error
Lamp error
Lamp End of lamp life detected
Burner Fan error
Lamp Fan error
Power Fan error
DMD Fan error
Case Open
DMD error
Color wheel error
In the event of an error, please disconnect the AC power cord and wait for one (1) minute before re-
starting the projector. If the POWER or LAMP LEDs are still blinking or the TEMP LED is lit, or any
other situation that isn't listed in the chart above , contact your service center.
Image Problems
Problem: No image appears on the screen
1. Verify the settings on your notebook or desktop PC.
2. Turn off all equipment and power up again in the correct order.
Problem: The image is blurred
1. Adjust the Focus on the projector.
2. Press the Auto button on the remote control or projector.
3. Ensure the projector-to-screen distance is within the 10-meter (33-feet) specified range.
4. Check that the projector lens is clean.
Problem: The image is wider at the top or bottom (trapezoid effect)
1. Position the projector so it is as perpendicular to the screen as possible.
2. Use the Keystone button on the remote control or projector to correct the problem.
Problem: The image is reversed
Check the Projection setting on the Installation I menu of the OSD.
Problem: The image is streaked
1. Set the Frequency and Tracking settings on the Computer menu of the OSD to the de-
fault settings.
2. To ensure the problem is not caused by a connected PC's video card, connect to another
computer.
r ' s M a n u a l
r ' s M a n u a l
r ' s M a n u a l
M
ODE ESSAGES
P LED
OWER
B
LINK
ON
ON
ON
OFF
4
5
5
6
6
6
6
7
8
9
– 42 –
R LED T
EADY EMP
B B
LINK LINK
ON OFF
OFF OFF
FLASHING OFF
OFF
4 OFF
OFF OFF
3 OFF
1 OFF
2 OFF
3 OFF
4 OFF
OFF OFF
OFF OFF
OFF OFF
LED
ON