Installing The Batteries To The Remote; Connect Power & Antenna/Cable/Satellite; Switching On/Off; First Time Installation - Telefunken 32XT750i User Manual

Installing the Batteries to the Remote

1. Lift the cover on the back of the remote upward
gently.
2. Install two AAA batteries. Make sure to match the +
and - ends of the batteries in the battery compartment
(observe the correct polarity.
3. Replace the cover.
Connect Power & Antenna/Cable/Satellite
IMPORTANT: The TV set is designed to operate on
220-240V AC, 50 Hz socket. After unpacking, allow
the TV set to reach the ambient room temperature
before you connect the set to the mains. Plug the
power cable to the mains socket outlet.
LNB
13V/18V
SPDIF

Switching On/Off

To Switch the TV On
Connect the power cord to the 220-240V AC, 50 Hz.
Press button. Then the standby LED lights up.
To switch on the TV from standby mode either:
Press the " " button, P+ / P- or a numeric button on
the remote control.
To Switch the TV Off
Press the " " button on the remote control or press
the button or hold the control switch on the Tv
until shut down, so the TV will switch to standby mode.
(Depends model)
To power down the TV completely, unplug the power
cord from the mains socket.
Note: When the TV is switched to standby mode, standby LED
can blink to indicate that features such as Standby Search,
Over Air Download or Timer is active. The LED can also blink
when you switch on the TV from standby mode.
02_MB80_[GB]_IDTV_TC_S2_BRONZE23_1910UK_32913W_10077883_50214472.indd 24 02_MB80_[GB]_IDTV_TC_S2_BRONZE23_1910UK_32913W_10077883_50214472.indd 24

First Time Installation

When turned on for the fi rst time, the "language
selection" menu appears. The message "Welcome
please select your language!" is displayed in all
language options listed alphabetically.
Press the "
required language, press OK button to select. "First
Time Installation" appears. Use "
Satellite to set the required country, and press "
select "Teletext Language". Use "
to set the "Teletext Language" and select "Scan
Aerial or Cable
Encrypted" using "
DiSEqC
Switch
Scan Encrypted as Yes if you want to scan coded
stations.
You can activate Store Mode option by using left or
right button. If the Store Mode is set to "enabled",
E-Pop option will be available in other settings menu. If
it is set to "disabled", Store Mode will not be available
after the First Time Installation.
Note: If Store Mode is enabled, some features may be
affected.
Press OK button on the remote control to continue
and the following message will be displayed on the
screen.
English - 24 -
" or " " button to highlight the
" or "
" button to
" or "
" or " " button. You can set
29.02.2012 14:27:22 29.02.2012 14:27:22
" button
" button