D-Link DSL 504T Configuration Manual
Hide thumbs
Also See for DSL 504T:
- User manual (115 pages) ,
- Manual (99 pages) ,
- User'smanual (20 pages)
Advertisement
Quick Links
Modem Configuration Guide
Dlink DSL 504T
Configuring in Layer2 PPPoE for Windows XP and 2000
CONTENTS
1. Network Configuration
2. Restore Router To Factory Defaults
3. Re-configure In Layer2 PPPoE
4. Optional
Please note: Some screen shots may differ due to different versions of
firmware used. Please have your router powered on and connected directly
to your PC via Ethernet cable before you begin
1. NETWORK CONFIGURATION
PPPoE connection does not require you to have an IP address or DNS
settings manually encoded on your network card. PPPoE connection uses
authentication to establish the Internet connection and its after doing this
that your router is assigned an IP and DNS settings from TPG.
To begin, your PC needs to receive a private IP address from the router.
Most ADSL routers have DHCP enabled by default that will take care of this.
To ensure your Network Card is ready for this please follow the following
steps:
A. Click on Start -> Settings -> Control Panel -> Network Connections
B. Find your Network Card then right click on this and select Properties
C. Double click on Internet Protocol TCP/IP
Dlink DSL 504T
1
Advertisement
Related Manuals for D-Link DSL 504T
Summary of Contents for D-Link DSL 504T
- Page 1 Modem Configuration Guide Dlink DSL 504T Dlink DSL 504T Configuring in Layer2 PPPoE for Windows XP and 2000 CONTENTS 1. Network Configuration 2. Restore Router To Factory Defaults 3. Re-configure In Layer2 PPPoE 4. Optional Please note: Some screen shots may differ due to different versions of firmware used.
- Page 2 Modem Configuration Guide Dlink DSL 504T D. Ensure “Obtain an IP address automatically” is selected E. Ensure “Obtain DNS server address automatically” is selected F. Click on OK 2. RESTORE ROUTER TO FACTORY DEFAULTS PLEASE NOTE: By doing this step you will be deleting any additional customised settings (if applicable) in your router, for example port forwarding.
- Page 3 Modem Configuration Guide Dlink DSL 504T D. Click Next to begin the setup E. Set the Admin Password on the router, for defaults type admin in both the Password and Verify Password fields. This password is used whenever you log into the router so it is important you remember what it is.
- Page 4 Modem Configuration Guide Dlink DSL 504T G. Please select / fill in the following fields: Connection Type: PPPoE LLC • Username: - <TPGusername>@L2TP.tpg.com.au for Fixed IP plans OR - <TPGusername>@PPP.tpg. com.au for Dynamic IP plans (e.g. adsl1234@L2TP. tpg.com.au) • Password: Your Password by default is the same as your <TPGusername>...
- Page 5 Modem Configuration Guide Dlink DSL 504T 4. OPTIONAL You router: If you had other services setup on your router like port forwarding and you had restored your router to factory defaults before configuring in PPPoE, please now reconfigure these functions to your current router settings.