Advertisement
Quick Links
FLOAT CAT 75
E E X X P P E E D D I I T T I I O O N N
ASSEMBLY AND OPERATIONS MANUAL
WARNING
Read Operations Guidelines before using.
Always wear USCG approved floatation devices.
Always wear wader safety belt.
Always attach tether while operating.
Do not operate in rapids.
Do not operate in high wind conditions.
ALWAYS USE COMMON SENSE.
Maximum capacity:
350 lbs. Float Cat 75
Advertisement
Related Manuals for Hobie Float Cat 75 Expedition
Summary of Contents for Hobie Float Cat 75 Expedition
- Page 1 FLOAT CAT 75 E E X X P P E E D D I I T T I I O O N N ASSEMBLY AND OPERATIONS MANUAL WARNING Read Operations Guidelines before using. Always wear USCG approved floatation devices. Always wear wader safety belt. Always attach tether while operating.
-
Page 2: Table Of Contents
Foot Rest ............5 From assembly to short of bringing in that record rain- bow, the friendly folks at Hobie Outback are available to Cargo Rack ..........5-6 answer your questions Monday through Friday at: (760) 758-9100 And they’re always curious to know how your Rowing Kit............6... -
Page 3: Float Cat Assembly
Hobie Float Cat Assembly FLOAT CAT 60/75 PARTS LIST Two pontoons Two black plastic vent caps Two aluminum crossbars with snap buttons One plastic molded seat back Two 10” aluminum seat posts with plastic C clamps Two seat post screws 3/4” Phillips One seat back adjustment system: One 1”x56”... - Page 4 STEP 2- The Crossbar Assembly Prior to installing any of the crossbars to the hull, it is easiest to partially build the crossbar first. Use the diagrams below to help with the assembly. Be sure to note how the extended portion of the hangers point toward the stern of the boat at all times.
- Page 5 STEP 5- Seat Bottom Lacing Short lacing lines Locate the two short and one long black lacings. Flip pontoons so that it is upsidedown. Using the two short lacings, tie a double half hitch at each outer grommet of the short flap.
- Page 6 STEP 8- Safety Tether Locate safety tether. Tie off the end of the stretch cord to either side of the rear crossbar. Always attach the teacher to yourself so you will never get separated from your boat. STEP 9- Caps Installing the vent caps (2) as supplied creates a water tight seal.
-
Page 7: Foot Rest
All hinged and molded joint parts of the Float Cat Rowing System are designed and made specifically for use on the Hobie Float Cat. The rigid structure of the Float Cat is used to complete the rowing system for maximum strength. Do... -
Page 8: Rod Holder
This increases speed, visibility, warmth, casting clearance and fin clearance (weedbeds, shallows etc.). It’s not just a step above float tubes, Hobie has created a new class of water craft for the angler. - Page 9 best performance of your Float Cat 60/75. These techniques can all be learned in one day but will take time to perfect. Have fun. Stability: Your Float Cat is very stable, but as with all small boats, you must have your weight centered and always be aware of tipping over.
- Page 10 Look back occasionally to see that you are going towards you target and steering clear of obstacles. Pivots: To pivot on axis, sweep one or both fins in a circular motion clockwise or counterclockwise. Your Hobie Float Cat should easily pivot 360 degrees from a stopped position.
- Page 11 wind-drift. Throw out a small marker buoy to mark your open water hotspot. A marker or an anchor will keep you from drifting away from your desired location. Trolling: Trolling flies or lures from your Float Cat can be quite productive and helps find new hotspots. Use your fins for slow trolling or the oars for faster trolling.
- Page 13 Warranty Hobie Outback warranties it’s Float Cat products to be free of all defects in material and workmanship for the period of Three years from date of purchase. Upon receipt and inspection Hobie Outback will repair or replace at no charge any boats returned during the warranty period that are found defective. Please do not return the product without our prior authorization.