Advertisement
rotate the stem to the proper time. Then, push the stem back, as you would a typical
watch or clock.
SETTING THE ON-SCREEN TIME STAMP ON VIDEOS
During video playback, device will show the Time Stamp in the lower right corner of
the video. Please set the time as follows:
1. Create a file named "Time.TXT" and edit it according to this format: 2010.12.12
NOTE: A sample Time.TXT document is on the software disc included
12:12:12.
in the package.
2. Copy the file to the root of the disk of the camera and disconnect the camera from
the computer.
3. When you operate the HD Camcorder Watch the next time, the Time Stamp will
be updated.
TECHNICAL NOTES
1. When taking video continually, the system will automatically generate a new video
file after each operation.
2. Please make sure you have enough power. If the device has low power, the red
light flashes 10 times, saves the current file automatically, and turns off.
3. For optimal sound recording, remove the Mic Cover Knob (4) completely. The Mic
Cover Knob (4) is located in the 4:00 position.
4. The time it takes for computers to recognize the HD Camcorder Watch varies.
Please be patient while your computer recognizes this device. If your computer
does not recognize the device, please make sure your operating system, drivers
and USB cable are up-to-date and in good working order, then try to connect
again.
5. For optimum battery performance, please charge the battery fully before the first
five times you use the HD Camcorder Watch. This will help the battery reach and
maintain its full capacity.
Advertisement
