Fastening The Adapter Cover; Using The Security Bar And Slot - Hitachi CPX10WN User Manual

Setting up

Fastening the adapter cover

Use the supplied adapter cover to
prevent the USB wireless adapter from
coming off easily.
1.
Loosen the screw (marked with
triangle) on the bottom right of the
USB TYPE A port.
2.
Insert the tab of the cover into the
hole at the upper left of the USB
TYPE A port in the direction of the
arrow.
3.
Align the screw holes on the
projector and the cover. Then
insert the screw removed from the
projector into the hole and tighten
the screw.
WARNING
to put in the mouth.

Using the security bar and slot

A commercially available anti-theft chain or
wire can be attached to the security bar on
the projector. Refer to the fi gure to choose
an anti-theft chain or wire.
Also this product has the security slot for
the Kensington lock.
For details, see the manual of the security
tool.
18 mm
WARNING
from falling down, since it is not designed for it.
CAUTION
It may become too hot.
NOTE
• The security bar and slot is not comprehensive theft prevention
measures. It is intended to be used as supplemental theft prevention measure.
16
►Keep small parts away from children and pets. Take care not
12 mm
10 mm
►Do not use the security bar and slot to prevent the projector
►Do not place anti-theft chain or wire near the exhaust vents.
1
2
Tab
12mm
Anti-theft
chain or wire
18 mm
Installation surface
3
Security slot
18mm
18mm
security bar