Denon PMA-1500RII Operating Instructions Manual page 8

ENGLISH DEUTSCH
6 Balance control (BALANCE)
This knob is used to adjust the balance between the left
and right channels.
When it is set to the center position, the amplitude of the
amplifier is equal on both sides. If the volume on the
right side is too low, turn the knob to the right (
volume on the left side is too low, turn the knob to the left
( ). This will achieve an even balance on the left and
right sides.
7 Volume control (VOLUME)
This knob controls the overall volume level.
Turn the knob to the right (
the left ( ) to lower it.
Recording output select switch
8
(REC OUT SELECTOR)
Use this to select the output source for recording onto a
tape deck, etc.
• TAPE-2 1:
Use this position when making copies of tapes using
two tape decks. The input signal from the deck con-
nected to the TAPE-2/MD input terminals is fed to the
TAPE-1/DAT REC OUT terminals.
• TAPE-1 2:
Use this position when making copies of tapes using
two tape decks. The input signal from the deck con-
nected to the TAPE-1/DAT input terminals is fed to the
TAPE-2/MD REC OUT terminals.
• PHONO:
Used to recording from the turntable.
• CD:
Used to recording from the CD player.
• TUNER:
Used to recording from the tuner.
• DVD/AUX:
Used to recording component that connected to the
DVD/ AUX terminals.
9 Input select switch (INPUT SELECTOR)
This switch is used to select the input signal for the pro-
gram source.
• TAPE-2/MD:
Use this position when using the tape deck, etc., con-
nected to the TAPE-2/MD terminals.
• TAPE-1/DAT:
Use this position when using the tape deck, etc., con-
nected to the TAPE-1/DAT terminals.
• PHONO:
Use this position when using the record player con-
nected to the PHONO terminals.
Use the CARTRIDGE selection switch
the sensitivity to correspond to the cartridge type
being used.
• CD:
Used to listen a compact disc player or other compo-
nent that is connected to the CD terminals.
• TUNER:
Used to play a component such as an FM/AM tuner or
a TV tuner that is connected to the TUNER terminals.
• DVD/AUX:
Used to play a component such as a HiFi video
player, TV tuner or tape deck that is connected to the
DVD/AUX terminals.
8
FRANCAIS ITALIANO
) to raise the volume and to
17
ESPAÑOL NEDERLSNDS SVENSKA PORTUGUÊS
10 Source direct switch (SOURCE DIRECT)
The controls (BASS
and BALANCE
the OFF (
When set to the ON (
). If the
are by passed and the signals are input directly to the
volume control circuit, providing high quality sound.
11 Power LED
The LED indicates the set's operating mode.
Main unit
power switch
ON ( )
OFF ( )
The mute mode is set for several seconds when the
main unit's power switch is turned ON (
standby mode is canceled by the remote control unit.
12 Remote Control Sensor
(REMOTE SENSOR)
This sensor receives the infra-red light transmitted from
the wireless remote control unit.
For remote control, point the wireless remote control unit
towards the sensor.
13 Iput terminals (INPUTS)
These are input terminals for CD players, turntables,
AM/FM tuners, tape decks or other playback compo-
nents.
NOTES:
• The PHONO input terminals are equipped with a
short pin-plug. Remove this plug to connect a
record player.
Store the removed short pin-plug in a safe place so
as not to lose it.
• Do not plug a short pin plug into the REC (record-
ing output) terminals. Doing so will result in a loss
of sound and may damage connected equipment.
14 Tape playback and recording terminals
(TAPE-1/DAT, TAPE-2/MD)
Playback and Recording Terminals
• Playback Terminals (PB).
• Recording Terminals (REC).
to switch
15 Pre out terminals (PRE OUT)
Use these when adding a power amplifier, a subwoofer
with built-in power amplifier, etc.
Connect these PRE OUT terminals to the input termi-
nals on the additional power amplifier, subwoofer, etc.
NOTE:
Signals are output from the PRE OUT terminals even
when using headphones.
If you wish to stop the signals, do so by operating the
connected unit (power amplifier, etc.).
, TREBLE , LOUDNESS
3 4
) can be used when this switch is in
6
) position.
) position, the above controls
Main unit mode LED color
Operating Lit orange
Flashing
Mute
green
Standby (power off
Lit red
by remote control)
Off
5
orange
) or when the