Advertisement
M1-14207(1)
1/3
1.
DISASSEMBLY
1-1.
REMOVAL OF CABINET, MECHANISM
UNIT AND MAIN BOARD
REMOVING
THE CABINET PARTS (Fig. 1.1 .1)
REMOVING
THE CP-I PWB ASSEMBLY (Fig. 1.1 .3)
1.
Remove the cabinet and bottom cover by removing the
After removing the cabinet parts and mechanism unit:
four screws (A) and five screws (B).
1.
Pull outthe TM-1 PWBAss'yfrom
CN301 and CN302while
2.
Remove the front panel by removing the locks of the
pressing and spreading out the four clamps (H).
clamps (C) using a screwdriver, etc. and slightly rotating
2.
Remove theholdersettothe
opening of thechassis, while
the bottom part in the direction of the arrow.
pressing the clamp in the direction of the arrow.
NOTE:
Electrical adjustments
for the this model can be
3.
Remove the two red screws (J). Next, remove the CP-1
performed with only the cabinet removed.
PWB Ass'y by lifting it straight up while pressing and
spreading out the two clamps (K).
REMOVING
THE MECHANISM
MAIN UNIT (Fig. 1.1.2)
After removing the cabinet parts:
1.
2,
3.
Remove the two screws (D), and then remove the bracket.
Remove the 29-wire flat cable from the MC-2 PWB, and
then remove the 1l-wire flat cable from the VP-1 PWB
Ass'y.
Remove the mechanism main unit by removing the two
screws (E) and two screws (F).
Remove, as well, the two screws (G) at the cassette tray
side while pressing the tray lock lever as shown in the
enlarged view arrow to remove the lock and pushing the
cassette tray to the position where the two screws
(G)
appear.
.
M-TEIIJE-1
Front
Panel
nit
ver
,,. ,.. ,
,!
Fig.
1.1.1
w
Advertisement
