Charging The Battery; Attaching The Belt Clip - Uniden MHS127 Owner's Manual

Setting up the Hardware

Charging the Battery

Your radio includes a charger and a rechargeable battery
pack. Place your radio in the charger with the display facing
forward. Make sure that the CHARGE LED on the charger
turns orange.
Cautions:
• Use only the battery and charger supplied with this radio.
Using a different charger or battery can damage the
radio and create a risk of fi re or shock.
• The charger is not waterproof. If the charger falls into
the water, unplug it before attempting to remove it from the water. After
you remove the charger from the water, please contact our Customer Care
Line.
• Wipe off dirt or shake water from your radio before placing in the charger if
your radio gets dirty or wet.
Important notes on charging the battery
• Charge the battery fully before using the radio. When the battery is
completely charged, the CHARGE LED turns green.
• Don't use the charger when the ambient temperature is below 0° C (32° F)
or above 45° C (113° F).
• If the radio is powered down, the battery can charge in about seven hours.
(If the radio is powered on, the battery takes longer to charge.)

Attaching the Belt Clip

To attach the belt clip:
1. Rotate the belt clip so that the fi nger indentation
is towards the top of the radio.
2. Align the center of the clip with the anchor post.
3. Place the clip on the post and slide the clip
upwards until it clicks into place.
UNIDEN MHS127
To remove the belt clip:
1. Rotate the clip so that the fi nger indentation is
towards the bottom of the radio.
2. Slide the clip up until it comes free of the
anchor post.
18
Handheld VHF Marine Transceiver