Panasonic BB-HPL11 Instruction Manual page 11

Nearly about the same time the setting button of the master unit and the
slave unit One I press seconds
Settings button
Almost at the same time
AboutOneI press seconds
PLCLamp
Of the parent machine, PLC Lamp ( PLC) Will start flashing green.
●
cordless handset During registration, "HD-PLCMaximum "network Ten Blocked is that seconds
●
It is for the network equipment that is connected to the adapter can communicate
It may disappear.
When the registration is complete PLC Lamp ( PLC) To green lights
If you did not light up in green, please press the Settings button again.
●
● After registration, about Thirty Seconds Do not unplug the power plug
There. There is that the registration has not been completed.
●
When you press the number of times setting button,PLC Lamp ( PLC) Is not lit in green
When the "HD-PLC"It is not connected to the network. Before the separate "your /
And "About the lamp display" of "when in trouble (+11 Refer to the page)
Sai.
The handset Two If you want to register more than die procedure by replacing the handset Two Repeat
Kara
Please operate.
After registration, disconnect the power plug from the power outlet, the adapter
To be installed in a location that you want to use (+ 12 Page)
●
Already of another "HD-PLC"The new slave unit which has been used in utilizing the network
When you register to the network, please do the initialization of the slave unit. (+16 Page)
Base unit
Cordless
PLCLamp
handset
Settings button
Almost at the same time
AboutOneI press seconds
Leve
Bei
To
That
Eleven