Table of Contents
Advertisement
3. Press
to select the record to be deleted. Press
OK
record.
4. Press
to confirm.
OK
Repeat steps 1 to 4 to delete another record.
Deleting the entire phonebook
1. While reviewing the phonebook, press and hold
2. Press
when prompted to confirm the action.
OK
The phonebook is now empty.
PROGRAMMING THE PHONE
Press
during standby to enter program mode. All programming
PROG
icons will appear in order with the first icon on the left flashing. You can then
press
or
to select the item you would like to program.
During programming, you can press
cancel the confirmation. Press and hold
program mode and return to standby.
Handset Ringer Melody & volume
1. Press
during standby and you will see
PROG
2. Press
to select.
OK
3. Press
or
to listen to and select from the 5 melodies.
4. Press
to confirm your selection and you will be prompted to volume
OK
Setting.
5. Press
or
to listen to and select from the different volume levels.
6. Press
to confirm your selection.
OK
is turned off.
Base Ringer Melody & volume
1. Press
during standby and press
PROG
flashing.
2. Press
to select.
OK
to delete
DEL
.
DEL
to go back to program mode or
EXIT
at any time to exit the
EXIT
flashing.
will turn on if the handset ringer
or
until you see
14
3. Press
or
to listen to and select from the 5 melodies.
4. Press
to confirm your selection and you will be prompted to volume
OK
Setting.
5. Press
or
to listen to and select from the different volume levels.
6. Press
to confirm your selection.
OK
You have the option to turn off the base ringer.
You cannot program the base ringer if the handset has lost link with the base.
UNAVAIL will be displayed. Re-establish the link and try again.
Recall duration
When you are talking on the phone, pressing
There are 2 factory programmed recall timings for you to choose from. Check
with your local telephone company if you are not sure which duration to set
and the functions performed with the flash signal.
1. Press
during standby and press
PROG
flashing.
2. Press
to select. The current duration is now displayed.
OK
3. Select 1 or 2 and press
to confirm.
OK
Dial mode
Tone or pulse dialing mode can be changed in this menu.
1. Press
during standby and press
PROG
flashing.
2. Press
to select. The current setting is now displayed.
OK
3. Select 1 for TONE or 2 for PULSE and press
If the dialing mode is set to pulse, you can press and hold the
temporary DTMF during off hook. "d" will be displayed on the screen. All the
digits dialed after "d" will be dialed as DTMF tones until you hang up.
Register
Each handset can register to one base at a time only. The current base will
be deregistered when a new base is registered.
Each base can register up to 2 handsets.
1. While in programming mode, scroll to the
2. Before you enter the PIN, press and hold
until a registration tone is emitted. The base is now in the registration
will send a flash signal.
or
until you see
or
until you see
to confirm.
OK
key to set a
icon and press
.
OK
on the base for 4 seconds
15
Advertisement
Table of Contents
