MAINTENANCE AND SERVICE
Replacing the dipped beam bulb
The dipped beam bulb in halogen headlamps
can be replaced by the driver.
Before the bulb can be replaced, the plastic
cover over the headlamp must be removed; see
the article "Bulb replacement".
1. Detach the headlamp's round rubber cover.
2. Unplug the connector from the bulb.
3. Detach the bulb by pulling straight out.
4. Replace the bulb.
5. The guide pin on the bulb must be facing
straight up when it is inserted into the
socket.
6. Press in the connector.
7. Refit the headlamp's rubber cover.
474
Related information
•
Bulb replacement (p. 472)
•
Bulb specifications (p. 477)
Removing the headlamp's oval
cover
Most of the headlamp's bulbs become accessi-
ble when the oval cover has been removed.
Before the oval cover can be removed, the plastic
cover over the headlamp must be removed; see
the article "Bulb replacement".
1. Unscrew the cover's four screws using a Torx
tool, size T20 (1). They must not be screwed
all the way out, 3 - 4 turns is enough.
Slide the cover to one side.
3. Remove the cover.
Reinstall the cover in reverse order.