Accessories - Chamberlain RSL12VDC Installation Manual

ENTRAPMENT PROTECTION DEVICES
PHOTOELECTRIC SENSORS (MONITORED,
NON-CONTACT)
The photoelectric sensors are designed to detect an
obstacle in the path of the electronic beam and
stop the operator. Includes mounting brackets.
Models CPS-UN4 and CPS-RPEN4GM (LiftMaster
low power accessory)
VEHICLE DETECTION DEVICES
PHOTOELECTRIC SENSORS (NON-MONITORED,
NON-CONTACT)
The photoelectric sensors are designed to detect an
obstacle in the path of the electronic beam and
stop the operator. Includes mounting brackets.
Models AOMRON E3K-R10K4-NR (retro-reflective)
and RETROAB 60-2728 (retro-reflective)
SENSING EDGE (2-WIRE, NON-MONITORED,
CONTACT)
Sensing edges can detect an obstacle upon contact
and stop the operator.
Models G65MG0204, G65MG0205, G65MGR205,
and G65MGS205
SENSING EDGE CHANNEL
Mounting channel for all MG020 type edges.
Model G65ME120C5
REMOTE CONTROLS
LiftMaster offers a variety of LiftMaster remote controls to satisfy your
application needs. Single-button to 4-button, visor or key chain. The
following remote controls are compatible with operators manufactured by
LiftMaster after 1993. Contact your authorized LiftMaster dealer for
additional details and options.
3-BUTTON REMOTE CONTROL
The 3-button remote control can be programmed
to control the operator. Includes visor clip.
Model 893MAX
3-BUTTON MINI-REMOTE CONTROL
The 3-button remote control can be programmed
to control the operator. Includes key ring and
fastening strip.
Model 890MAX
KEYLESS ENTRY
Enables homeowner to operate gate operator from
outside by entering a 4-digit code on a specially
designed keypad.
Model 877MAX

ACCESSORIES

MISCELLANEOUS
45
REMOTE ANTENNA EXTENSION KIT
The remote antenna extension kit allows the
antenna to be remotely installed.
Model 86LM
COMMERCIAL ACCESS CONTROL RECEIVER
Access control receiver for up to 1,000 devices
(any combination of remote controls and wireless
keyless entries).
Model STAR1000
PLUG-IN LOOP DETECTOR
Conveniently plugs into existing control board.
Model LOOPDETLM
LOOP DETECTOR
Low power loop detectors mounted and wired
separately inside control box. LiftMaster low power
accessory.
Model LD7LP
VEHICLE SENSING PROBE
The vehicle sensing probe is buried in the ground
and can detect a car as it approaches and will then
open the gate.
Model CP3
SOLAR PANEL KIT - 10 WATT
This kit is to replace or add a solar panel to the
operator application. Up to three solar panels can
be connected to the operator in parallel
configuration.
Model SOLPNL10W12V
MAGNETIC GATE LOCK
Outdoor magnetic lock, transformer, junction box,
mounting plate and hardware. Not for use with
Solar Applications. Must be powered separately.
Model MG1300
HEATER
Keeps operator gearbox and batteries at suitable
temperature when outside temperature is below
0°F (-18°C) for extended periods of time.
Model HTR