Epson PhotoPC 800 Service Manual page 62

EPSON PhotoPC 800
4.2.0.5 CA2 Board and PW1 Board Removal
Here shows the removal of CA2 board, PW1 board, the holder battery and
holder lens. Follow the order in the figure.
If you replace the CA2 board or CCD, refer to Chapter 5 and
perform necessary adjustment.
Disassembly and Assembly
13.Holder Battery
11.Remove
the solder.
C
8.Screw 1.7x4
C
12.PW1 board
5.Screw
1.7x4
3.Remove the
solder.
JEP-4
Figure 4-6. PW1 and CA2 boards, Holder Battery and Holder Lens Removal
Disassembly and Assembly
NOTE: If only PW1 board is replaced or removed, it it not necessary to
remove the solder of earth terminal on the CA2 side.
7.Screw1.7x4
10.CA2 board
9.Connector
6.Screw
14.Holder lens
3.Remove the solder.
4.Earth
Terminal
2.Stand
1.Screw 1.7x4
Revision A
1.7x4
62