Advertisement
JAM PROOF SYSTEM OPERATION*
Eliminates frustrating jams by preventing overloads and powering through misfed paper.
*100% Jam Proof when used in accordance with user manual
SLEEP MOdE
WHEN IN SLEEP MOdE
2
1
In sleep mode
To get out of sleep mode
touch control panel
BASIC PROdUCT MAINTENANCE ANd TROUBLESHOOTING
OILING SHREddER
All cross-cut shredders require oil for peak performance. If not oiled, a
machine may experience diminished sheet capacity, intrusive noise when
shredding and could ultimately stop running. To avoid these problems, we
recommend you oil your shredder each time you empty your waste bin.
FOLLOW OILING PROCEdURE BELOW ANd REPEAT TWICE
1
2
AUTO
AUTO
*Apply oil across entry
Shred one sheet
*Only use a non-aerosol vegetable oil in long nozzle container such as Fellowes 35250
PREvENTIvE MAINTENANCE ANd MISCELLANEOUS TROUBLESHOOTING
• Self Cleaning Cycle: Shredder periodically cycles in forward and reverse lasting 3-6 seconds (C-225Ci).
• Empty wastebasket when bin full indicator lights up.
• Shredder won't run if the door is open, or bin needs to be emptied.
• Maintenance is an important part of protecting your investment. Don't forget our oil (35250) and shredder bags (36054).
Go to Support Section at www.fellowes.com or see back page of manual for useful telephone numbers.
Advanced Jam Prevention- Electronically
1
measures paper thickness to prevent paper jams:
Up to RED: Too Many
sheets have been inserted.
Up to YELLOW: Productivity
is optimized.
Up to GREEN: More sheets
can be added.
If a misfeed
All indicators light up and
occurs:
shredder pauses for 3-6 seconds
3
AUTO
AUTO
or
insert paper
3
AUTO
Press and hold forward
( ) 2-3 seconds
2
Remove several sheets until
indicator is below red.
Wait for flashing to stop after automatic correction
is complete. Regular shredding will resume.
SAFESENSE
TECHNOLOGY OPERATION
®
SET-UP ANd TESTING
1
2
AUTO
AUTO
Turn the shredder ON
Touch test area and
( ) to activate SafeSense
look for the SafeSense
®
indicator to illuminate
CLEANING AUTO-START INFRAREd SENSORS
Paper detection sensors are designed for maintenance free operation. However, on rare occasions the sensors
may become blocked by paper dust causing the motor to run even if there is no paper present
(Note: two paper detection sensors are located in the center of the paper entry)
TO CLEAN THE SENSORS
1
2
AUTO
Turn off and unplug
Locate Auto-start
shredder
infared sensor
15
3
Continue 100% Jam
Proof Shredding
If
illuminates after paper has been
reversed, press reverse and remove paper.
Otherwise, regular shredding will resume.
3
4
AUTO
AUTO
SafeSense
is active and
If hand is held on SafeSense
®
working properly
area more than 2 seconds
®
Shredder will shut off
.
3
4
AUTO
AUTO
Dip cotton swab in
Using cotton swab, wipe
rubbing alcohol
away any contamination
from the paper sensors
®
3
Advertisement
