Kidde KN-COSM-ICA User Manual page 19

Operation
®
The Hush feature can be used repeatedly until the air
has been cleared of the condition causing the alarm.
®
While the unit is in Hush mode, pushing the
®
Test/Reset/Hush button on the alarm will also end the
®
Hush period.
®
NOTE: Dense smoke will override the Hush control
feature and sound a continuous alarm.
®
CAUTION: Before using the alarm Hush feature,
identify the source of the smoke and be certain a safe
condition exists.
Reset Feature
If the the Smoke/CO Alarm is sounding a CO alarm,
®
pressing the Test/Reset/Hush button will silence the
alarm. If the CO condition that caused the alert
continues, the alarm will reactivate. Reactivation times
depend on the amount of CO present.
Peak Level Memory
If the CO sensor has detected a CO level of 100 PPM
or higher since last reset, it will be recorded by the
Peak Level Memory function. To access the Peak Level
®
Memory, press the Test/Reset/Hush button. If a
reading of 100 PPM or higher has been recorded, the
unit will announce, "Caution! Attention!" If you've
been away from home, this feature allows you to
check if there was a CO reading of 100 PPM or higher
®
during your absence. Pushing the Test/Reset/Hush
button resets the memory. The memory is also reset
when the unit loses power.
17