Zoom - Kyocera KM-2560 Advanced Operation Manual

Sending Functions

Zoom

2-6
Scans the original by automatically zooming it depending on the sending
size.
The table below lists the available options.
Item
100%
Auto
NOTE:
When zooming in or out, see Sending Size Selection on page 2-4
when selecting the sending size.
When Custom Size or Size Entry is selected as the original size, the
originals are sent at normal size and zooming cannot be used.
Depending on the combination of original size and sending size, the image
is placed at the edge of the paper. To center the image vertically and
horizontally on the page, use the centering setting described in
on the page 2-7.
Use the procedure below to enlarge or reduce the original to match the
transmission size.
1
Place the originals on the platen.
2
Press the Send key.
3
Select the transmission size.
4
Press [Advanced Setup] and then [Zoom].
5
Press [100%] or
[Auto].
6
Press [OK].
7
Specify the destination, and press the Start key to start sending.
Detail
No Zoom (to be scanned at actual size)
Zoomed automatically according to the specified
sending size.
Ready to send.
Place original .

Zoom

Enlarge or reduce original when scanning .
[100%]: Scan at actual size.
[Auto]: Enlarge or reduce to match
Press [OK] to display
sending size/storing size.
the image.
100%
Add Shortcut
Status
ADVANCED OPERATION GUIDE
" "
Centering
Destination
1
Auto
Cancel OK
10/10/2007 10 :10