Argus DC-5190 User Manual page 20

Flash will not fire
Flash set to OFF -Set the flash to Auto or On.
Flash has not been fully charged The flash takes
a few seconds to charge up while the Operation
LED is blinking. Flash light is fully charged
when the Operation LED turns off.
Battery level is low - When the battery indicator
does not show a fully charged battery, the
voltage is too low for the flash to work. Please
change batteries.
Image is blurred / out of focus
Subject is out of focal range. Ensure that there
is at least 1.5m ( 5ft ) between the camera lens
and subject. Camera moved during the shot-
Hold the camera steady while taking the picture.
When flash is on, hold the camera steady until
flash has fired twice( The first flash is to reduce
red-eye and to detect the brightness of the
target.)
Computer does not recognize camera for
Windows 98SE, The camera driver has to be
installed before picture download. In picture
preview mode, ensure that USB mode is set to
MSDC before connecting the camera to the
computer. For Windows 2000/ ME /XP, the
camera is recognized as a plug -&-playable,
removable flash disk without driver installation
under MSDC mode. It is recommended that you
disconnect your digital camera from your
computer after use.
20