Toyota SP10 Seies Instruction Manual page 13

4
Pass the thread end through the
hole of the bobbin as shown.
5
Place the bobbin on to the
thread winding spindle so the
groove will meet the shaft
projection.
6
Hold the thread end and push the thread
winding switch to the left and start winding.
7
After winding a little, release the thread
winding switch to the right and stop winding.
Note: While pushing the winding switch
to the left, thread winding spindle
rotates.
8
Cut extra thread above the bobbin hole.
9
Push the thread winding switch to the
left again.
Wind the thread in the amount you need.
10
To stop winding, release the thread
winding switch to the right.
Attention
Do not wind excessively,
it causes sewing
malfunction.
11
Remove the bobbin from the spindle. Cut the thread.
Thread
Hole
Thread winding
spindle
right
Groove
Shaft projection
wrong
13