®
Installation, Operation and Maintenance Instructions
SAFETY WARNING:
Improper installation, adjustment, alteration,
service or maintenance can cause property damage,
injury or death. Read the installation, operating,
and maintenance instructions thoroughly before
installing or servicing this equipment.
WARRANTY
Greenheck warrants this equipment to be free from
defects in material and workmanship for a period of one
year from the shipment date. Any units or parts which
prove to be defective during the warranty period will be
repaired or replaced at our option. Greenheck shall not
be liable for damages resulting from misapplication or
misuse of its products. Greenheck will not be responsible
for any installation or removal costs. Greenheck will not
be responsible for any service work or backcharges
without prior written authorization.
RECEIVING AND HANDLING
Upon receiving dampers, check for both obvious and
hidden damage. If damage is found, record all necessary
information on the bill of lading and file a claim with
the final carrier. Check to be sure that all parts of the
shipment, including accessories, are accounted for.
Dampers must be kept dry and clean. Indoor storage
and protection from dirt, dust and the weather is highly
recommended. Do not store at temperatures in excess of
100°F (38°C).
Due to continuing research, Greenheck reserves the right to change specifications without notice.
This manual is the property of the owner, and is required for future maintenance. Please leave it with the owner when the job is complete.
Document Number 452763
FD, DFD, SSFD, SSDFD, & KFD Models
11/2 and 3 Hour Curtain Fire Dampers
FD, DFD, SSFD, & KFD models are intended for installation in
accordance with fire damper requirements established by:
National Fire Protection Association
NFPA Standard 80, 90A, & 101
IBC International Building Code
CSFM California State Fire Marshal
Fire Damper Listing (#3225-0981:102)
New York City (BSA/MEA listing #260-91-M)
"UL CLASSIFIED (see complete marking on product)"
"UL CLASSIFIED to Canadian safety standards (see complete
marking on product)"
UL Standard 555 (Listing #R13317)
Installation Supplements
Refer to the appropriate Greenheck installation supplements
for special requirements:
• Close Indicator Switch
• Concrete Floor with Steel Deck
• Drive Slip Breakaway Connection
• Fire Resistant Ventilated Duct Assembly
• Firestop Material
• Greenheck Test Switch
• Grille Installation
• Metal Stud in Shaftwall
• Quick Connect Breakaway Connections
• Sealant Supplement
• Single Side Retaining Angle
• Single 3-Sided Retaining Angle - Vertical Mount
• Sleeve Extension
• Support Mullions
Note: Refer to Greenheck IOM, Part #461335, for CFSD
models to be installed in corridor ceiling applications.
These instructions apply to 11/2 and 3 hour rated fire dampers
mounted (blades must be horizontal) in masonry, block or
stud walls and concrete floors. Specific requirements in these
instructions are mandatory. These instructions meet the
requirements of UL 555. Installation shall comply with the
requirements of NFPA 90A Standard for the Installation of
Air Conditioning and Ventilating Systems. UL listing R13317,
California State Fire Marshal listings 3225-0981:102, and
New York City BSA/MEA listing 260-91-M apply to these
dampers.
Note: Fire dampers are manufactured and labelled for either
vertical or horizontal installation. The dampers must be
installed in accordance with the labelling.
Vertical and Horizontal Mount