Page 1
Simple and intuitive usability High value The EINSTEIN The Final Cut amplifier is not a component, which sounds nice, soft or bright. Our goal is to integrate a component into your existing system, which minimizes its impact on the musical signal. The mono-blocks transfer the signal directly to the loudspeakers.
Page 2
When selecting a placement for your amplifiers, please consider proper ventilation of the units as well as a solid platform for the units to be placed on. The Final Cut should never be placed on top of other compo- nents nor should other components be placed on top of it. Due to the massive transformers you should not place a turntable or phono amplifier next The Final Cut amplifier.
Page 3
Power switch To turn power to The Final Cut on or off, please use the left switch on the front panel of the chassis. Three blue LED’s and lighting of the tubes indicate the status of the amplifier. The Final Cut is ready to play after approximately 5 minutes when both outside LED’s are switched off.
Page 4
11. Tubes The Final Cut uses 6C33 type tubes, which have a lifecycle of approximately 2000 hours. In order to maintain the amplifiers fidelity only the same kind tubes should be used as replacement, as these have been fully checked and tested by our lab.
Page 5
15. Warranty Your EINSTEIN The Final Cut amplifier comes with a 3-year warranty (tubes 6 months) if the following conditions are met: Return of the supplied warranty card and appropriate customer information stamped by your dealer within 30 days No modifications of any kind were made to the unit Return of unit for service or repair in only the supplied original packaging The warranty is not transferable.